answersLogoWhite

0


Best Answer

Vehicles that are around 96's and up have an OBD-II computer link up. This palm held pluggin unit costs around $125 - $150 ish online or at the autopart stores a bit more.

The beauty of it is it will diagnose your check engine light problems and tell you what it is so you know what to have replaced. It also resets the light and clears the codes.

I purchased one and it has been invaluable as it works on any vehicle 96 and up. From Chevy to Ford to Porsche to Rolls Royce.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you diagnose a problem with your '96 Chrysler Sebring LX yourself?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Chrysler sebring convertable 2000 not fiering?

my 98 Chrysler Sebring cv is not fiereing need information own what maybe causeing this problem


Signs that there is a problem with the electronic relay in a 2002 Chrysler Sebring?

i just put a new computer in my 2002 sebring and now I am having a problem starting the car


If a 1999 Chrysler Sebring convertible will not put out heat and it is not the thermostat or coolant level what is the problem?

I have the same problem I am ready to jack the chrysler up and install a Toyota underneath it


My 99 Chrysler sebring keeps shutting off when i drive. what can the problem be.?

change MAP sensor


Can a cam shaft sensor problem cause a 2002 Chrysler Sebring to stall and not restart?

Yes.


How much does sunroof repair cost for a 2003 Chrysler Sebring?

That will depend on the problem. Could be $100-$1000.


What can be the problem on a Chrysler sebring if the gear is stuck in park?

If it is a 2007-2010 there is a spring retainer on the shifter that breaks.


What is wrong if a 1996 Chrysler Sebring computer reads 'cam position sensor no signal'?

There is a problem with the cam sensor or the wiring to it.


Chrysler sebring won't start after going through puddle?

If the Chrysler Sebring won't start after going through a puddle, the problem is probably that the starter relay switch got wet. This is not a common thing but if the starter relay was bad to begin with, moisture will make the problem worse. The starter relay is located on the starter.


On a 2002 Chrysler sebring If the 2.7 engine turns over but seems to have no compression what might be the problem?

A broken timing chain is possible.


I have a 2007 chrysler sebring 2.7l that will not start without spraying starter fluid in the air filter Does anyone know what the problem is?

If the 2007 Chrysler Sebring 2.71 is not starting without stater fluid in the air filter is could indicate a faulty starter or the air filer may need replacing.


How can I fix 2000 Chrysler Sebring JX instrument cluster voltage problem?

Using a multimeter and spark tester will help find the source of a voltage problem on a 2000 Chrysler Sebring. Having a repair manual on hand will troubleshoot the system, but many electrical problems require tedious sifting through wiring to find the faulty short or ground which is causing an issue.