Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Ford > Ford Probe > How do you disassemble a slave cylinder for a 94 Ford Probe SE?

How do you disassemble a slave cylinder for a 94 Ford Probe SE?

In: Ford Probe, Ford F-150 [Edit categories]

Answer:

the slave cylinder is easy to replace. you cant dissassemble it. to replace it simply look down where the engine and transmission meet from under the hood. you will see a line and a bleeder screw. from there just disconnect the line, plug it, and remove the two bolts holding it in. installation is reverse. just remember to bleed the air out of the lines by cracking the bleeder screw and have someone pum the clutch until the air is out

First answer by ID1166356367. Last edit by ID1166356367. Question popularity: 1 [recommend question].

[report abuse]

Can you answer these Ford Probe questions?

	Why is Youtube the least reliable source for media?	Answer it!
	Why is your ford probe idling funny and overheating?	Answer it!
	Where is the block heater on a ford probe gt?	Answer it!
	How do you change the turn signal switch ford probe?	Answer it!
	What is a light probe?	Answer it!

Relevant answers:

Where is the slave cylinder on a 1993 ford probe?
many 93 ford probes have the slave cylinder and the brake pump as one. ford had a great idea of putting those two together. its the drivers side off in the back right by the wheel base.
How do you bleed the slave cylinder on a 1989 Ford Probe?
There is a bleeder valve on the front of the clutch slave cylinder right next to the line running in. You pump the clutch a little and then you hold it to the floor while someone opens the valve and...
How do you work on 94 ford probe 4 cylinder?
What work needs done? You will need a good set of metric tools, and the rest depends on what is wrong with the engine.
Where is the slave cylinder located on a 1989 ford probe?
In the front of the transmisson, right by the radiator. Its about 6-7 inches long and its bolted into the bell housing and connected to the clutch fork
What are the cylinder numbers on ford probe?
the cylinder numbers are the following if you are facing the front of the car looking at the motor:1 3 52 4 6the firing order is 1,2,3,4,5,6