Find the pass time under the dash or wherever it is by following the remote sensor eye to the box. There is a five wire plug attached to the pass time device. Disconnect this plug. You can take the pass time out now but your car wont start. To solve that, cut the purple and the blue wires from the plug you just disconnected. Strip the insulation off the ends and twist and solder them together. You can use a crimp if you'd like too but solder would be better. Wrap electrical tape over the exposed splice. Cover the end of the plug with tape as well just to be safe. Tie the wires out of the way with a cable tie and put whatever you took apart to get to it back together. You are then done.
If you want to simply disable the device from affecting your starter but leave it in the car so that it will still take codes and "appear" to be working, then leave the device plugged in and just splice the purple and blue wires together as before.
It's probably illegal to do this unless you have paid off you car, so I'd check that first.
If your car is paid off chances are the dealer will remove it for free if you ask since he could then reuse the device and they do cost more to buy than to pay to have removed and installed.
You cannot do unless you will disconnect the bipper. If you do so you can loose warranty for your car, and do not pass the state inspection next time. Or you could put your seatbelt on........
disconnect battery cables
If working on the electrics of a car then it is a sensible precaution to disconnect the battery.
Paige Simpson
unplug it from under ur dash cut the blue and purple wires and tie them together
How do you disconnect the ABS in a 1996 Lincoln Town Car
remove the pass. finder linner and find plug to the motor and disconnect it
I am researching this myself due to a faulty alarm that keeps me from starting my own car. As soon as I get the answer I'll pass it along.
Your car doesn't turn on.
Easyer to just disconnect battery for the time the car is sitting up.
depends on times you have had it
You can disconnect your 1999 Chrysler 300 car alarm by removing the car alarm fuse. The car alarm fuse can be found in the fuse box.