0
i can tell you how to do it, if you have a good knowledge of engines it's not hard but is time consuming. you can call me at 636-575-0255, thanks harry
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
On a 1996 Chevy Suburban the brake system incorporates a dump valve What does this dump valve do and or where is it?
The brake dump valve on a 1996 Chevy Suburban is used for bleeding the brakes after new brake pads are installed. It is located on the master cylinder for each brake.
What is the cost for a valve job on a 1999 GMC suburban?
A valve job for your 1999 GMC Suburban will cost approximately $800. The parts will cost around $200 and require 10 hours of labor.
Where is the heater valve in a 1994 Chevy Suburban?
where is the heater control valve on a 1994 2500 suburban
How do you seal an intake valve on a 1996 Chevy blazer?
Do a valve job. This is more complicated than it sounds, you might be better off sending the head to your local machine shop for the valve job.
Need location of expansion valve on a 1997 Chevrolet Suburban?
Where is front expansion valve for chevy suburban 1997
What is the gear ratio on a 1996 2wd suburban 1500?
What is the gear ratio on a 1996 2wd suburban 1500?
If 1993 suburban rear ac not cold how can check the expansion valve?
If 1993 suburban rear ac not cold how can check the expansion valve?
Where is the PCV valve on a 2002 Chevy Suburban 6.0 liter engine?
The PCV valve on a 2002 Chevy Suburban 6.0 liter engine is located in the engine. You cannot miss the valve.
How do you Tune up 1996 Chevy Suburban?
There are several things that needs to be done for a tune up on a 1996 Chevrolet Suburban. Some things that need to be done are an oil change, replacing spark plugs and plug wires, and a new distributor cap, rotor, PCV valve, air and fuel filters.
Where is the pvc valve located on a 2001 suburban 5.3L?
where is the pcv valve located on a 2001 chevy suburban It is stuck in a rubber hose and pushed into the top rear drivers side valve cover.
How do you fix a sagging door on a 1996 suburban?
You can fix a sagging door on a 1996 Suburban by replacing the door pins and the bushings.
How do you tell difference between exhaust valve and intake valve on 1998 suburban 5.7?
The intake valve is bigger.
