How do you do the timing on a Acura Integra gsr?

Answer 1

1 Disconnect the cable from the negative terminal of the battery.[If the radio in your car has an anti-theft system make sure you have the correct activation code before disconnecting the battery] 2 Place blocks behind rear wheels and set parking brake. 3 loosen the lug nuts on left front wheel and raise the front of the car. Support the front of the car securely on jack stands. 4 Remove the left front wheel and splash shield from under the engine. 5 Support the engine with a floor jack.place a block between oil pan and jack pad to prevent damage to the oil pan. 6 remove the upper left engine mount bracket. 7 remove spark plugs and the engine drive belts.8Unbolt the Power Steering pump with out unplugging hoses and set it aside.9 Remove the oil dipstick. 10 Position the number one piston at top dead center. WARNING Always rotate the crankshaft counterclockwise[viewed from the pulley end of the engine]. {Clockwise rotation may cause incorrect adjustment of the timing belt}. 11 Remove the upper timing belt cover. 12 Remove the drive belt idler pulley and bracket from the front of the engine. 13 using a strap wrench or chain wrench to hold the crankshaft pulley stationary, loosen the crankshaft pulley bolt with a socket and breaker bar. 14 slip the pulley off the crank shaft. 15 Remove the dipstick tube from the front of the engine. 16 Remove the lower timing belt cover. 17 If you intend to reuse the timing belt,use white paint or chalk to make match marks to align the sprockets with the timing belt and an arrow to indicate the direction of rotation. 18 Loosen the timing belt tension bolt. Push on the tensioner to release the tension on the belt, then re- tighten the bolt. remove the crankshaft fluctuation sensor and slip the belt off.