about $17. It covers models from 1995 to 2003. It shows pictures of how
to replace parts and how to do electrical tests to see if parts are good.
Remove the plug on the bottom of the power steering fluid pump. Drain the power steering fluid out. Replace the plug to the bottom of the power steering pump. Replace the power steering fluid.
how to drain 1999 windstar
To replace power steering fluid on a 95 Geo Metro, open the hood. There is a large yellow knob labeled with powering steering fluid only. Drain the old power steering fluid and place new fluid.
Lift the Acura. Drain the power steering fluid. Disconnect the steering joints from the power steering rack. Unbolt the race and remove. Install the new rack and connect the steering back up.
Drain the fluid from the power steering pump. Remove the power steering hose. Remove the wiring harness from the power steering pump. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.
You will need to drain out the old fluid first. Then you can put in the new fluid and test out the vehicle.
The fuel pump is located on top and inside the fuel tank. You must drain and remove the fuel tank to replace the fuel pump.
Power steering never has a drain plug.
Below the steering. In the middle of the steering.
No drain plug so a good old fashioned siphon hose or hand pump.
On the 2002 Windstar there is a 3/8" square head antifreeze drain plug above the starter. This drains the left bank of the block and can be replaced with a 1/4" pipe valve.
Locate the power steering gear box and drain the fluid. Locate the bolts and remove them. Pull the arm. Detach the steering wheel from the steering linkage. PullÊthe linkage until it dischargesÊfrom the gear box. Loosen the bolt on the gear box and remove the box.