You must frame it with 1x4 or something like that first. Then apply drywall to the 1x4.
Depending how strongly they must be fixed I would use plastic or alloy EZE-anchors.
You have to replace the fuse for it You have to replace the fuse for it
Take it to the mechanic
One can fix wall units to the wall by using the screws, bolts and other equipment provided with the unit when it was purchased. There will be directions with it as well.
He takes prts from other dead wall e's, and uses him o fix himself
It will cost between $50 and $100 to fix a small dent in the wall, if you hire a carpenter. An individual can fix the small dent in the wall for less than $20.
You can fix it with glue
20
It would depend on what is wrong with it.
== == If you're asking about the electrical socket outlet itself, usually two screws fix it into its wall outlet box.There are several ways to mount an electrical outlet box. Depending where you live, just go to your local Home Depot, B&Q, Homebase, Wickes or any similar hardware or DIY-supplies store and look around the section for electrical parts. If you're asking about the wall outlet box, usually 2 nails or screws fix it. If it's mounted into a hollow wall built using wooden wall studs and sheetrock/plasterboard, the nails or screws fix the box to the closest wall stud. If it's mounted into (or onto) a brick wall, the nails or screws fix the box to the brickwork.If not nailed or screwed to a wall stud in a hollow wall, an electrical outlet box can be held-in with a pair of "jiffy clips" or the box itself has flip-up ears that clamp it to the sheetrock/plasterboard. These types of boxes are known as "EZ-Boxes". As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed. If you do this work yourself, always turn off the powerat the breaker box/fuse panel BEFORE you attempt to do any workANDalways use an electricians test meter having metal-tipped probes(not a simple proximity voltage indicator)to insure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
no
Get a plastic sheet and then cement it