Well, I have a "90 Legacy. There is a red release button on the belt fastener riding the rail. release it and see if the fastener doesn't return to top or bottom. I'm not sure what causes this, but the above fix works for me. Just reconnect the belt (it only goes one way) and get on with your life. Hope this helps.
Your clutch cable snapped. It should be an easy fix.
Check the 1991 Legacy for a stuck thermostat. Check to make sure that the water pump is working properly.
Water Leak upper or lower hose Water Pump Failure Thermostat Stuck in Closed Position Blown Head Gasket Fit new radiator cap
You could be low on coolant, a stuck thermostat, engine fan not coming on for starters. If still overheats, I would recommend taking it to a Subaru dealer.
You can not close any door if the locking mechanism is stuck in the locked position. You must first get the mechanics to unlock.
Turn the steering wheel back and forth if that doesn't work try that screw under the steering column
It is not, my Subaru Brumby is working fine thank you
your clutch cable located at rear of motor is snapped, bro autopartswarehouse.com has one for $50 bucks, bro easy fix
Check your temperature control switch. It is hooked to a cable it could be stuck on hot or needs a new one.
(1) The thermostat is probably stuck in the closed position, needs replacement, or (2) the water pump is not operating, needs replacement. Most likely: Thermostat.
The coolant is not circulating through the radiator. The thermostat may be stuck in the closed position or the belt that rotates the water pump may be loose. Could also be a bad water pump. Or, if it is very cold and you don't have enough antifreeze, the coolant may be frozen and not circulating.
its right in the front middle of the engine/ unscrew the bolt and pull it strait up/ if it gets stuck in the hole you will have to use a drill and carefully poke holes in it and brake it apart then pull it out