If it's a 1999, here you go. Three screws on the bottom of the plastic panel. Remove the speaker grille by pinching the ends and easing it out. Then look for three deep-set screws. Yank them. Then there's a screw in the recess hand grab handle, as well as by the door handle grab. There is either a speaker or a blank in the corner of the window that has four screws; two on the front portion, two on the inside after the cover comes off. The speaker or blank is two pieces; one that attaches to the door frame and one that attaches to that piece. There are either two or three nylon push screws that I would conisder sacrificial. Once all the fasteners are off, pull the panel from the bottom and you will fins a wiring harness and a door linkage arm. The blue plastic clip on the edge of the arm at the door handle rotates off on the same plane as the rod itself. Then remove the four or five wiring devices. The black plastic sound deadener is glued on and will come off if you're careful. Hope this helps.