I had the same problem. I had to remove the bulb (careful not to touch it with your fingers). Then I took a piece of cardboard and rollied it into a cone-shaped tube. I taped it one end to a hair dryer and inserted the other end into the hole where the bulb goes and left it on for about 15 minutes. Make sure all of the moisture is gone and be sure to seal the boot that covers the bulb so moisture does not get in.
== ==
You are going to have to replace the entire Headlamp Assembly, very expensive.
open hood. just behind light assembly there are two white nylon clips pull up then slide off nipples on back of light assembly. pull the whole light assembly out of front of car unhook the plug and light is free. reverse for installation.
Remove the fasteners and electrical connection from behind the assembly and slide the assembly out the front.
remove front headlight assembly to get at horn,it is down below light assembly..
Pop the hood. Remove the front shroud cover to expose the radiator and light assemblys. Remove the head lamp assembly by removing the vertical light brackets. These brackets are vertical metal holders for the lamp assembly. They are removed by pulling up and there are two per side. You will see them once you remove the front shroud cover which exposed the light assembly's. The light brackets will have hard rubber attached to the top on each one to facilitate their removeall. Once you have removed the brackets, the entire light assembly will slide forward. You will need to guide the wiring so that you can slide the light assembly forward. Once you have the entire assembly slid forward you can remove the light socket from the back of the assembly and change the bulb.
Front of the car, built into the headlight assembly. It is the orange light nearest the tire.
Remove the headlight assembly and you will have access to the parking light bulb.
Open hood, there will be 2 black metal slide locks in the back of the light assembly. After that, work the light assembly out the front, disconnect the plug and change out the light.
There is a single screw above each front parking light assembly. You will need a 7mm socket to remove the screw. After the screw is removed, simply pull on the assembly from the back corner and pull straight forward.
The bulbs go in from the rear. You may have to remove the light asy, by removing the top plastic rivet and sliding the whole assembly toward the front to disengage the three plastic assembly tabs.
They are on the back side of the instrument cluster. You have to pull the assembly out from the front.