Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Chrysler > Chrysler Fifth Avenue > How do you get the horn working on an 1988 Chrysler Fifth Avenue the relay and fuse has been changed still no power going to horns at the front?

How do you get the horn working on an 1988 Chrysler Fifth Avenue the relay and fuse has been changed still no power going to horns at the front?

In: Chrysler Fifth Avenue [Edit categories]

Answer:

Answer

Have you verified that there is no power going to the horns? If there is no power going to the horns, and you have replaced the relay and fuse, then don't forget to check the horn switch in the steering wheel. You may need to check the actual wires throughout the horn circuit to make sure they're intact and connected. After 20 years anything is possible. Good luck.

Contributor:

Eyknough

First answer by ID0405548346. Last edit by Eyknough. Contributor trust: 32 [recommend contributor ]. Question popularity: 56 [recommend question].

[report abuse]

Can you answer these Chrysler Fifth Avenue questions?

How do you install a electric fuel control system?

Answer it!

Relevant answers:

Location of Chrysler horn relay?
According to various publications, you can find it under the hood in a fuse box, or under the dashboard on the driver's side in a fuse box. However on the 1991 New Yorker I have been suffering with...
Where is the horn relay and horn fuse located on a 1979 corvette?
Both, the horn relay and the horn fuse are located under the dash panel on the left side of the steering wheel. The fuse is a 20 amp fuse, lower left side of the fuse panel (which is somewhat...
Why new horn don't work with good relay and fuse and power going to its terminal?
you have to make sure you have a good ground , also depending on the vehicle it may have power all time at the connection end of horn , the switch may only supply a ground, one other thing depending...
Fuse for the horn 2006 Chrysler 300?
Front Power Distribution Center Fuses, #4 - 20 Amp Yellow