 |
How do you go about installing a clutch in a 1992 Geo Storm? |
[Edit] |
Answer
this procedure is time consuming however any one can do this so go for it. first write down the radio station pre-sets. then disconnect the negative battery cable.half of the drive train will be removed from the car so manufacture some sort of support for the engine half. then loosen but do not remove the wheel lug nuts and c.v. axel shaft nut at the wheel. raise the front of car as high as possible with strong supports such as jack stands ect. remove the front tires and axel shafts. next remove the starter wiring and other wiring from the transmission as well as clutch cable or slave cylinder and shift linkage remove the transmission and set aside. remove the clutch assembly and in my opinion buy a new one this procedure is long and involved dont skimp on someone elses rebuilt parts. re install in the reverse order.
First answer by dadinfo. Last edit by dadinfo. Question popularity: 56 [recommend question]
|
Research your answer: |
Answers.com > Wiki Answers > Categories > Cars and Vehicles > Parts and Repairs > Transmissions and Drivetrains > Clutches and Flywheels > How do you go about installing a clutch in a 1992 Geo Storm?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
