CAUTION: Make sure that no obstructions are present in the power rear window system when carrying out this procedure.
NOTE: The rear window motor is in error mode when shipped and will be inoperative until initialized.
NOTE: This procedure must be carried out when repairs are performed on any part of the power rear window system including when: the power rear window motor is removed from the window regulator drum housing, a new power rear motor is installed, a new power rear window regulator is installed, a new power rear window glass module is installed, and any operation in which grease or lubricants are applied to the power rear window system.
NOTE: All power rear window components (window glass module, window regulator, window motor, and glass runs) must be installed and torqued to specification before carrying out this procedure.
NOTE: Once the ignition key is turned to the ON position in Step 6, it must remain on until the entire procedure is completed.
NOTE: Step 7 requires that the power rear window control switch be held in the CLOSE position (fully clockwise) until the power rear window motor stalls the window into the upper header seal. Step 8 requires that the window control switch be momentarily turned to the OPEN position.
NOTE: Step 9 requires that the power rear window control switch be held in the CLOSE position (fully clockwise) until the window stalls into the upper header seal and the window carries out its down-up sequence, indicating successful completion of initialization.
NOTE: The key-in-ignition chime can cause the vent button to be pressed more or less than six times due to the distraction of the chime.
Start with the ignition in the OFF position. Open the driver door.
NOTE. You will need to close the door after step 6.
if the motor is turning then it could be off the track or a gear might be stripped.
Begin by removing the inside door panel of your 2001 Mercury Villager. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install your new window motor.
== ==
yes
replace rear window wiper motor on 2001 Chevy venture
did you also replace the regulator? sometimes its the regulator that goes bad and not the motor.
The plastic on the rear window motor of a 2001 S-10 Blazer is black. It surrounds the majority of the motor and is easily distinguishable from the metal.
Remove the inside door panel. Unhook the wiring harness from the window motor. Remove the retaining screws. Reverse the process to install the new window motor.
Trade it in for a Holden
the switch is on the door panel approx four inches from the window, this is the only switch that sends power to the window regulator motor (window motor).
electric window motor bad or switch is bad check the motor and see if its getting power if so motor is burnt up if not switch is bad
The window will often fall down on a 2001 Nissan Xterra due to a faulty drive motor. This causes the tension that holds the window in place to release.