If you crush it and put water on it and it doesn't GEL UP! then yes, you can dilute it with water and inject it, but you need to know how much you can handle or you will OD and die very quickly. Once that plunger on the needle pushes all the drug into your arm the time for choices is over!
first, you must remove the time release coating on your pills. This can be done by "washing them," or you could just scrape it off or suck on it until it is devoid of color. Once you have a white pill, you crush it and empty the powder into a spoon. Draw up into your CLEAN, NEW syringe about 75 cc of water for every pill you plan to inject. I would not recommend injecting more than 80-100 mg at a time, especially if you are a noob. I could easily snort 3-400 mg and banging just under 100 puts me on MY A$$. Anyway, spray the water from the syringe onto your powdered pills (gently, so as not to upset the powder.) Mix the water and powder together until you have a homogenous pasty substance. Then take the cotton from one end of a QTip or a comparable amount of cotton, ball it up tightly and drop it into your solution. Then gently stab the cotton with the syringe (enough to penetrate, not fully impale so the cotton acts as a filter,) and draw up the injectable form of the drug into the syringe. Sterilize your injection site with alcohol and resterilize your needle to avoid "cotton fever," tourniquet your arm and insert the needle. When you think you have entered the vein, you will need to pull VERY GENTLY on the plunger. If blood enters the chamber, you are in the vein. If not, keep stabbing. DO NOT DEPRESS THE PLUNGER UNTIL YOU ARE 100% POSITIVE YOUR NEEDLE IS IN YOUR VEIN. Once inside, SLOWLY depress the plunger and withdraw the needle. Sterilize again; before you remove your tourniquet. Put away all your supplies before your remove it, because once you do, you may have 25 seconds before you are hit by a ton of bricks. DONT STOP READING YET, because here comes the most important part; the $#!tty part. You must......
Sterilize, resterilize, and sterilize again. When you're done, DO IT AGAIN.
The tiniest piece of cotton filter on the tip of your needle can penetrate your veins and will give you cotton fever.
Reuse of a needle will eventually and inevitably dull your needle, so don't reuse.
Reuse of a filter will keep your needle from drawing clean, so DON'T REUSE.
Reuse of any one vein more than maybe twice a week will result in Embolis, Thrombosis, and a real sonofabitchinly painful and swollen injection site (which I consequently am on here trying to find a solution for)..... sooo, you guessed it DO NOT REUSE.
I will also assume you have the common sense to not use someone else's needle or share yours; and if not, stop using altogether. The idiot junkies give us responsible addicts a bad name ;) ENJOY YOUR FLIGHT
You inject OxyContin OP with an intramuscular injection.
Yes, but it has to be prepped.
can you shoot oxycontin 60mg
The new OP stamped Oxycontin is in stores now!
Yes
NO, there's Oxycontin with a op in it. Those can't be crush to snore them.
Yes how would it not show up
Yes. Exactly the same. But I wouldn't recommend doing it.
They are twice "as strong" the dosage a 30mg = 0.03grams of Oxycodon; 60mg = 0.06grams. Check the related link for safety information. Doubling the dose does not have a linear effect ( that means it is not twice as good or effective ). It will have a greater impact on the pain but also an increased potential for side effects and toxicity.
Sig; Oxycontin, 80 mg, every 4-6 hrs. as needed. No OP's though. OP brand is harmful to your engine and may cause permanent damage.
Yes both contain oxycodone a opiate used for severe pain relief.when the test is run oxycodone will show up depending how long it was last used.
Ask for ethex brand of oxycontin.it is the original formula
Perdue pharma changed all pills to an anti abusive pill all pills will have op on one side and the dosage on the other
Sure is!