Take the battery out and find something to cut the old wires off and attach the new ones you will also need a crimping tool
Disconnect the Regal battery cables. Find the battery clamp then remove it. Lift the battery out, then put the new one in. install the clamp, then connect the battery cables.
disconnect the battery cables. find the battery clamp and remove it. Lift the battery out, then set then new one in place. Install the clamp, then connect the battery cables.
remove negative and positive cables,take battery holddown bolt off,remove battery! when installing new battery, battery hold down first then install the cables , neg first!dont forget to reset radio.
Remove cables from battery Remove + cable from the starter solenoid Remove the - battery cable from engine ground install new cables using the same routings as original
To replace the battery cables on a 1999 Mercury Mountaineer, loosen the connectors at the terminals. After this, remove the other end of the cables and install new ones.
disconnect the 97 Thunderbirds battery cables. Find the battery hold down and remove it. Lift the battery out, then lower the new one in. Install the clamp and hook up the cables.
1) find suitable location for 2nd battery 2) install battery cables + to+ and - to-.
Remove the cables from the top of your battery. Remove the battery stabilizing retaining bolts. Reverse the process to install your new battery.
Remove the cables from the 2001 Monte Carlo, then take out the battery hold down. Lift the battery out and put the new one in. Install the hold down, then connect the cables back.
Buy a new battery to start off with then you will have to either change the battery cables to sidepost type mounts or buy sidepost type mounts and install them on your old cables.
Remove the cables from the battery posts. Remove the battery retaining bolts. Lift the battery out of the retaining box. Reverse the process to install the new battery.
First take the cables off then the hold down then lift the battery out. Clean the battery box with a mixture of soda and water then spray it with WD40 then install the new battery and clean the cables before you reinstall them.