0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Codes about using teflon tape to install gas piping?
There are approved Teflon tapes for "gas" but it depends on the HJA and what type of "gas" your asking about
There is only a trickle of cold water coming out of the cold tap in the kitchen the pipe is blocked took the stopcock off and it has disintegrated and think the fiber washer fell into pipe?
Sounds as though you have galvanised piping. Your only solution there is to take the section of piping out and inspect it at the next joint and see whether the condition of the piping is adequate. If not take out the next section of piping until you find that the piping is in better condition. My recommendation is to replace with copper, for two reasons, copper does not corrode and is easy to install. Would be advisable to replace the stopcock and even in some cases the tap as well.
What is the difference between a piping designer and piping engineer?
Designer mostly drafting, piping engineer mostly calculation
How much does a plumber charge to install a new water line?
This depends on what material the plumber uses, what fittings the plumber uses, how much piping will be used and how long the plumber will take.
What the difference between process piping and utility piping?
Process piping contains the product or piping integral to the process of creating the product. Utility piping is supporting the process but is not integral to the process, typically fresh water, cooling water, steam, condensate
Can you install salt system with copper piping?
Yes, if you're talking about a water softener, you can use copper piping.
How do you remove plaster of Paris from drain pipe?
You cant, you have to remove the section of piping and install a new section of piping.
What is the water pressure from an overhead tank?
That depends on the extra height of your tank, its capacity and the bore of your piping.
Can you install union inside a wall?
If referring to gas piping, NFPA prohibits this.
I am looking for storage options for my garage and would like to install overhead storage. How do I go about doing that?
You can find a detailed guide on how to install overhead storage on the following site: http://www.ehow.com/how_2155827_install-overhead-storage-garage.html. It is fairly easy to do.
How easy is an overhead garage door opener to install?
It can be pretty eary to install a overhead garage door opener but to be on the safe side it is a better idea to have a professional do it for safety
How do you install a home geyser and do the piping?
Material 1. Geyser 2. Piping 3. Elbows 4. T Pieces 5. Vacuum valve 6. Pressure valve 7. Safety valve
What if the ac 5 ton unit is install what it will cost four the piping?
$1200 to $1500 depending on the length of run
Codes about using teflon tape to install gas piping?
There are approved Teflon tapes for "gas" but it depends on the HJA and what type of "gas" your asking about
What the difference between process piping and power piping?
What the difference between process piping and power piping?
What is Industrial Commercial Insulation Business?
Industrial Commercial Insulation (ICI) is owned by Tim Alexander (my father) and Tim Blackwell. They install piping insulation
Where is hot water tank located in home?
There are a number of factors that determine where the plumbing contractor decides to install it. If it is a gas heater, it needs to be located where it can be vented to the outside. Typically the heater should be as centrally located as possible to facilitate hot water getting to all of the fixtures it is attached to. They will attempt to minimize the length of the piping runs. Takes less piping and less work to install.
