0
All you have to do just unlose the belt tensioner after you unlose it and replace with a new one and tight it up before you able to unlose you have to take the cover off underneat the engine in order to able to take the belt off the ac pulley, it takes you only 10 min or less. any question aaasian@wmconnect.com 208-409-7212
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is timing belt located on 95 Mercury Villager?
The timing belt is inside the timing cover.
How to install a block heater on 1998 Mercury Villager?
I have a 95 villager and it came from the factory with a block heater.Look around the headlights for the plug tucked away.
Is it safe to remove the ac compressor belt on a 95 mercury villager - What else does this belt turn?
shouldn't run anything else, my 94 doesnt.
Where is the fuel tank on 95 mercury villager?
Under the car by the back axle.
95 mercury villager engine power?
You have to ask a more complete question.
Where is located tps sensor on mercury villager 95?
It is mounted to the rear of the throttle body.
How do you bleed a 95 mercury villager mini van?
Need more information. What are you trying to bleed?
How do you tighten an alternator belt on a 95 Ford Taurus?
You have to install a new belt tensioner.
How much oil does 95 mercury villager take?
According to the ( 1996 ) Mercury Villager Owner Guide : With engine oil filter change : The 3.0L V6 engine takes ( 4.2 U.S. quarts / 5W-30 PREFERRED )
What would cause water to pour out of the driver's side of the motor on a 95 mercury villager?
A broken hose, most likely.
How do you replace the fule pump in a 95 mercury villager?
The fuel pump is in the fuel tank, and the fuel tank will have to be removed to access it.
When do you change a thermostat on a 95 mercury villager?
There is no recommended interval, but if you are draining the system for any reason, that would be a good time to do so.
