If you have not already done so, go to the website for the maker of your rifle- most have an owner's manual that you can download for free. Generic instructions for a sidelock percussion cap rifle- others are different-
1. Use the ramrod to insure that rifle is not already loaded. If empty:
2. Place a cap on the nipple, and fire the cap (to clear any oil in the nipple)
3. Measure a charge of black powder, and pour down the barrel.
4. Give the rifle a slight twist/shake to settle powder
5. Place a greased cloth patch across muzzle of rifle. Place ball on top of patch
6. Use a ball starter to push the ball into the muzzle, and down an inch or two
7. Use ramrod to push bullet down barrel, until it is FIRMLY seated on top of the powder.
8. Remove ramrod, put back in storage spot
9. Cock hammer. Place fresh percussion cap on nipple.
10. If not shooting immediately, with muzzle pointed in safe direction, lower hammer to safety position.
11. When ready to shoot, bring hammer to full cock, pull trigger
EYE PROTECTION IS A MUST.
don't believe any such item as 58 cal. black powder pellets. but, there is a 58 cal. slug for the 58 cal. black powder rifle
yes
what is this rifle worth?
need a fair price of what it might be worth for an old richland arms 45 cal. black powder rifle with serial no. 2142
50-200 USD
Contact the maker of your rifle for their instructions. It will depend on bullet weight. Assuming you mean a .50 cal MUZZLELOADER- and not a .50 Barrett- between 75 and 90 grains of ffG black powder is an average load for a patched ball.
110 any more you just blow power out of the muzzle.
No published sn data.
its a pretty gun that only blonde would use
50-350 usd
100-300 USD
A good place to start is with as many grains as the cal. (30 in this case)and work up from there to find the load that gives the best groupings. I shoot 35 gr. for target and 40 for hunting and 45 with a mini ball in my 32's