Tensioner pulley below the alternator. Should be a 14 or 15mm socket and turn counter-clockwise.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
To loosen the tension on a serpentine belt on a 2005 Grand Caravan 3.8L, turn the nut of the belt tension pulley to loosen it. Adjust the belt, then tighten the tension pulley by turning the nut in the opposite direction.
If it
If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.If you are referring to the Serpentine belt, you loosen no pulley. You simply remove tension from the belt. The tension is applied by the Idler Pulley. Pry the idler back and remove the belt.
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
Ajustment bolt is located at the bottom of power steering pump.
If it is a drive belt and not a serpentine belt is has no tensioner. You manually adjust the tension by normally adjusting tension by moving the alternator. Loosen to bolts holding the alternator in place and then adjust the tension. Tighten the bolts when the tension is right. If it is serpentine belt if you follow the belt around the the engine you will see the tensioner.
Changing the serpentine belt on a 97 Mitsubishi Diamante is a fairly easy task. All you need to do is get a wrench and loosen the tension pulley and pull of the serpentine belt.
Serpentine belts use an pulley to keep tension on the belt. You need a breaker bar; attach to the tension pulley and turn the nut. One way will not move and the other way will loosen the belt. It will usually then just slide off that pulley and then come off all the rest.
the Serpentine Belt on the 91 Lebaron is on Tension Pulley, you dont tighten it. But if it is loose and you need to tighten it you just go and buy a new belt and put that on.
the idler pully makes the tension. to remove belt you use a wrench push tensioner in a direction that would loosen the belt as if you were trying to tighten or loosen the bolt holding the pulley on. carefull high tension.
You could do what I did, wait for the tension pulley to fall off the van...