Your local pool store should have pH decreaser.
Answerby buying a chemical called pH minus AnswerHi Aaron,You can use the pH Minus product mentioned or you can go purchase some Muriatic Acid. Be careful using this as it does have a very strong odor and is harmful if breathed or stays on your skin too long. I've used both pH Minus and muriatic acid. My experience with pH Minus (a dry acid) is that it worked just fine in lowering my pH level. I've have good luck, and quick results, in lowering my pH levels and Total Alkalinity levels, which has been a very big problem for me this season thus far.
You want to maintain your pH levels at about 7.6 - 7.4 .
You can use muriatic acid. Just be careful as it's, obviously, acidic and will eat through 5 layers of skin before you can wash it off. Goggles, and rubber gloves for safety.
Also, run your pH between 7.6-7.8, not 7.4. The pH in water will naturally rise and when you get your alkalinity in range, about 80-100ppm, your pH should be locked in at 7.6-7.8. You'll need to use too much acid to keep your pool pH lower. Most "pool experts" say to run your pH around 7.2, and that's just plain wrong.
They get their info. from an index used by your local water treatment system, and not from an index specifically designed for pools.
Dry acid is about 4 times more expensive than muriatic acid. Chlorine is about 80% efficient at a pH of 7.2 and only 40% efficient at 7.8 meaning it takes twice as much chlorine at the higher pH to provide equal sanitation. Keep the Total Alkalinity at a minimum of 100ppm even if you have to add a little baking soda once in awhile, especially if you are using any dry or tablet form of stabilized chlorine (isocyanurates).
Hello
Acording to my wife who deals with our pool, she said you have to reduce the pH balance by putting in some PH minus then make sure the water has been swirling about for a while it will then reduce the PH level then look at the tester to get the right colour hope this has been helpful
Tony
Soda ash is an excellent product specifically for this purpose.
Add Muriatic acid to the water. CAREFULLY
Add Muriatic Acid. Always check your pool chemistry after changing the pH.
Go to the local pool supply store and buy the necessary chemicals.
Muriatic Acid....Be real careful though.
By adding muriatic acid
buy PHminus
add a PH reducer chemical
To adjust pH and/or lower alkalinity.
Bicarbonate will RAISE the pH and total alkalinity.
You have to know what you are doing. The addition of muriatic acid lowers the pH and total alkalinity in swimming pools.
No. You will also get a bad smell or odor from your pool water. Where did you get this idea????
raising the pH level of the swimming poolThe recommended pH-range for a swimming pool is between 7.2 and 7.8. To raise or lower pH, alkali such as sodium carbonate (soda ash) or sodium bicarbonate (baking soda) will added to the water. thanks hope it helps you heaps!!
my sack
No it cannot. Sodium bicarb has a ph of 8.4. To lower ph you would need to use a dry acid (sodium bisulphate) or muriatic acid. City water is normally treated and has a ph of 7.5 but it would take a large amount of fresh water to lower the ph of a pool.
Rain if it is acidic can lower the pH of a swimming pool.
Soda Ash
Lowers the Ph
You can lower the PH level by using this stuff called PH Down. Go to a local pool store and ask about it.