like so?
http://beta.tulsaengineer.org/uploads/MouseTrap.bmp
If in a well replace it as it is worn out. If something was stuck in it set the ball on the seat and the spring on the ball to push ball to seat, then the ball retainer. Pressure should push the ball open and the spring should close the ball. (make sure all the spring is there)
I real don't want to tell it because it is an assignment but it is a tennis ball
With interchangeable rubber washers and bushes and ball bearings can make the bleeding stop.
You could make an aluminum disc with cutouts for ball bearings. Like a groove. Make two of them, put some ball bearings in between them and that should hold. Maybe make the aluminum anywhere from an 1/8 to 1/4 inch thick aluminum discs. Or steel your preference. Look up a lazy susan.
First you take a lond string and attach it to your arm then you get bouncy ball and add it to you Arm, now you have an Rigid Arm Pendulum.
A dint in the surface of a pingpong ball can be removed by putting the ball in hot water. The hot water will expand the air inside the ball and push the dint out, restoring the original shape of the ball.As to a hole? A hole would allow the pingpong ball to fill with water.
don't shove the snake in the holeI have never made a ping pong ball launcher before, and was wondering if anyone has any ideas on a good design. It has to be less than 1 sq. ft in volume.
because the wheel make the mousetrap go forward but without the wheels the mousetrap stays in one place
you can not really but you could just get something and put it on the mousetrap and some string but that is a good question how about you think yourself i think that would be good make it the best for you
Use Cd's as wheels to make less friction
go on dangeroulyfun.com
Tape a spoon to the bar that is attached to the spring.Take off the piece that holds the cheese and the piece that holds the bar downPull the spoon back and place the ping pong ball in the spoon.LET GO!!
it really doesn't matter unless you have dogs, cats, or any kinds of animals. if you do make sure they can't reach the spot where you put the mousetrap.
First, you drop the ball first to the right of the biggest ball.Then, cut the left chain of the red ball and drop it into the launcher on the right and cut the chain launcher for that one.The ball should go flying upward and bounce of the biggest ball. Drop the biggest ball when it is swinging to the left. This will make it fall into the crevice above the green ball. Then, drop the green ball into the left launcher.It will fly upwards, bounce off the biggest ball, and fly into its green cup. Now there should only be the red ball and a gray ball on a chain. Drop that ball. It will fall onto the red ball, and the red ball will roll into its red cup. By the way, do'nt worry about Inca level 8. That is 2 E-Z! Happy Civiballing! :D
use a lawnmore
It's actually very easy... All you have to do is to fix together a box-like structure (you could use a beyblade ripcord launcher) and a piece of elastic string. Attach the string to the launcher.
Stretch a rubber band between your fingers.