answersLogoWhite

0


Best Answer

Technically, what you have is sludge buildup. Most oils deposit sludge on engine surfaces. Sludge is a waxy substance that precipitates out of heated oil. Unfortunately, there is little that can be done to completely clean out sludge from the inside of an engine except for a complete engine rebuild. The good news is, the sludge won't cause too much trouble all by itself unless a large mass is dislodged and plugs up the oil pickup screen in the bottom of the oil pan. I run fully synthetic oil in my vehicle because synthetic oil has far less sludge production. Unfortunately, you should not change to synthetic oil if your vehicle has more than 50,000 miles on it. You can use some engine cleaner additives to the oil that will partially disolve some of the sludge, but if you decide to do that make certain that you change the oil at short intervals to get out everything that disolves.

All of the answer above has nothing to do with the question. Oil sludge is a bottom side of the engine problem. The person asking the question already informed us it is carbon buildup in the exhaust. I don't know of a easy way to correct this except to remove exhaust system from the headers back and clean with carb cleaner. Then use a fuel additive to clean the injectors and cylinders.

ANSWER#3

I had a 97 Jimmy with a similar 4.3 Vortec under the hood that you might have 8/10 chances for that year. If you just bought the vehicle and discovered this, you might have had a previous owner that drove the vehicle with low acceleration which caused the high amount of blowby in the PCV and the carbon deposits slowly and coolly being left along your exhaust system. One way is to get a fresh oil change (thicker is better in summer), and drive the vehicle hard. I'm not saying to break the law as that is not something one should do. I'm just saying you can accelerate in such a way that you can maximize some hot air pressure going through the system for a week or so. This usually does get rid of built up carbon in the air exhaust system.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you or can you remove the carbon build up on a 1995 gmc jimmy I removed the erg valve and it was full of carbon how can you do more from other areas that has built up?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How could cutting down trees lead to the build up of carbon dioxide in the atmosphere?

Because trees remove carbon dioxide from the atmosphere, and if they cut them down we will have more carbon dioxide.


How do you stop carbon build up on cooking pans?

To stop carbon build-up on cooking pans, soaking the pans in warm water and soap and then scrubbing with an abrasive cleaning tool will help remove the build-up. If the carbon resists, then it's recommended to buy a pumice stone to scrape the stain off, but this is advised for only stainless steel pans.


How do you solve carbon build up in a 2002 jeep 4.0 engine?

Use this product as instructed to remove carbon buildup, and use it every 6 months thereafter. Click the link.


What do you use to remove heavey carbon build up from the copper botom Revere Ware?

Elbow grease, an SOS pad, and a bit of water.


How do you remove the 2nd bulb out of the right rear tail light in a 1989 Volvo 240 dl wagon?

First you have to remove the cover after cover is removed turn the build holder counter clockwise


How do you get the exhaust flaps out of a 2001 Cr125 cylinder?

You first need to remove the side cover at the top of the cylinder on the right side. Once this is removed you will expose the power valves and power valve actuator rod. You will need to remove a cotter pin that holds the actuator rod to the power valve shaft. You can then remove the power valve shaft. The power valves will come out through the exhaust port. It is best to have the cylinder head removed and expansion chamber removed for access. If the shaft wont pull out it is because of carbon build up. You will need to spray the shaft and valves with solvent. The shaft should pull out.


How do the respiratory and the urinary system work together to remove waste from your body?

The respiratory system aids in keeping the pH level stable throughout the body, as well as, increasing blood flow to the needed areas. The renal system is dependent on the proper amount of blood flow in order to work properly. Toxins and wastes in the blood stream are filtered through the kidneys and are excreted in the urine. If the renal system is not working properly the waste and toxins remain in the body.


What do the three astronauts have to build in order to avoid being poisoned to death by the polluted air?

A co2 filter to remove the poisonous carbon dioxide from the air.


What do the three astronauts have to build in order to avoid being poisoned to death by the pollution air?

A co2 filter to remove the poisonous carbon dioxide from the air.


What does a yellow flame mean on a gas water heater?

You need a orifice cleaning to remove carbon build up on the flame tube and main burners.


Why do you continue to breathe faster after finishing strenuous exercise?

-To remove carbon dioxide in the body To break down any build up of lactic acid in muscles


Knowing if your car has carbon build up?

You can know if your car has a carbon build up when there are granular substances in the combustion chamber.