Want this question answered?
get raped by your dad.
Dish Network satellite receivers can be programmed to operate on different remote control addresses. Switching to a different address is necessary if you have 2 satellite receivers or if your neighbor's receiver is set on the same remote address and they are changing your channels. # Press the Mode button until the remote is in the SAT mode. # Press the Address button once (the SAT mode light will start flashing). # Use the numeric key to enter an address between 1 and 15 (do not put a 0 in front of single-digit addresses; 1 is the default remote address). The SAT mode light will stop flashing and stay lit. # Press the Address button again to save the change to the remote control. If you entered a valid remote address, the SAT mode light will blink 3 times. # Make sure the satellite receiver is Powered-off. If not, power the satellite receiver off and wait 15 seconds. # Press the Info button on the front of the satellite receiver. This will bring up the "Important System Information" menu. # Press the red Record button the the remote. The screen will update and the "remote address" listed on the screen will change to the new remote address of the remote control.
ws- 4500
چطور شبکه های ماهواره را تنظیم کنم تا بهم نریزن؟
30% of 4500= 30% * 4500= 0.3 * 4500= 1350
6% of 4500= 6% * 4500= 0.06 * 4500= 270
36% of 4500= 36% * 4500= 0.36 * 4500= 1,620
21% of 4500= 21% * 4500= 0.21 * 4500= 945
4500
4500
5% of 4500 = 4500*5/100 = 225
4500