Close the garage door.
Push the learn button on the back of the drive unit (receiver), light comes on.
Hold down button on the remote opener (transmitter) and wait until light flashes on the drive unit and then it's programmed.
I learned the hard way you cannot program a rolling code transmitter and a billion code transmitter to the same unit, what happens in this case is when you clear all the codes by holding down the learn button on the drive unit for 6+ seconds (which clears the codes), then do the programming sequence above for the remotes, (if you have 2 remotes and one is a billion and one is a rolling) only one will program at a time.
Visit the Related Link for a one-page manual.
You need the basic technical skills to program the craftsman garage door opener 139.53964 srt. The user manual usually has the steps on how this can be done.
no
the programing is unpossible, is so old this model, strach...
On my RX 350 and Craftsman opener I just pushed the memory button on the Craftsman opener briefly (the signal light came on next to the button) and released it. Then I pressed the sender in my car within 30 seconds. It wasn't long before the lights on the opener flashed and I then released the Lexus button. Didn't have to hold anything down very long at all.
how do you program your garage dorr opener to your Volvo 2001 v70
How do you un program garage door opener
program garage door opener for honda ridgeline
how do I program a garage door opener for a 2002 chevy venture
quick way to program garage opener with 2007 cadillac escalade.
how do i program my garage door opener to work with my 2006 dts cadillacqe
how do you program my garage door opener in 2009 gmc yukon
On back of motor unit is a red button next to an LED. Push button until LED stays on. Go to keypad, enter your nex code then press <Enter>. Viola!
rolling