Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Ford > Ford Trucks and SUVs > Ford Explorer > Ford Explorer XLT > How do you program keyless entry remote on 1997 explorer?

How do you program keyless entry remote on 1997 explorer?

In: Ford Explorer XLT [Edit categories]

Answer:

1997 Ford Explorer key fob programming

Key fob id:

FCC ID GQ43VT4T

DOC 1470 K763

TRW inc. 3165189

Three button, lock, unlock, panic

Cycle ignition from OFF to RUN or ACC five (5) times within 10 seconds, ending in RUN or ACC. All doors will lock then unlock to confirm programming mode. Press any button on 1st remote transmitter. Door locks will cycle to confirm programming. Press any button on 2nd transmitter (up to 4 transmitters total possible). Turn ignition to OFF. The door locks will lock then unlock to confirm programming.

First answer by ID3640616954. Last edit by ID3640616954. Question popularity: 4 [recommend question].

[report abuse]

Can you answer these Ford Explorer XLT questions?

	Is there difference between brake disc and brake rotors?	Answer it!
	Why are brake drums and rotors on a car thick?	Answer it!
	Where is the fuse of fuel pump relay on Mercedes W124 E220?	Answer it!
	How many tons is a F750 Ford?	Answer it!
	Where is the fuel pump on ford puma?	Answer it!

Relevant answers:

How do you program the remote keyless entry for a 1997 Expedition?
Replacing lost transmitters Take all your vehicle's transmitters to your dealer for reprogramming if: ² a transmitter is lost or ² you want to purchase additional transmitters (up to four may...
How do you program the remote keyless entry for a 1997 ford thunderbird?
1. Turn ignition to RUN or ACC. 2. Momentarily jump pins in programming connector located in LR quarter panel area (Connector will not be plugged into anything, it will have two pins inside it, if...
How do you program keyless entry remote for 1997 buick lesabre?
Follow this link and you're good to go. Let me know if you have any questions. I've done this myself so I know how to do it. .ehow.com/how_7291758_program -remote-1997-buick-lesabre.html#ixzz1HA...
How do you program the remote keyless entry for a 1997 Mustang?
Open the trunk lid and remove the left inside panel. Behind that there is a programming connector. It will be an un-used, open connector, probably grey, and that has two pins. the wires going to it...
How do you re-program a keyless entry remote for a 1997 Bravada?
Unless you http://wiki.answers.com/wiki.phtml?title=Special:Userlogin&returnto=How_do_you_re-program_a_keyless_entry_remote_for_a_1997_Bravada your contributions will be anonymous. However, your...