locate the "tensioner" pulley, on the schematic that is under your hood, on top of the radiator. Then place a socket on the bolt head in the middle of that pulley, and with a breaker bar, pull the entire pulley towards the front of the van, releasing the tension, and letting the belt slip off easily. Repeat this procedure once you have the new belt routed around most of the pulleys properly and slip it over the tensioner pulley last. Double check belt alignment on all pulleys, make sure it is well tensioned, then start your van and let it idle about 5 to 10 seconds, shut it off, and recheck the belt alignment and tension. If all looks well, then close the hood and call it a job well done.
Does a 1995 dodge caravan SE have an interference engine?" Does a 1995 dodge caravan SE have an interference engine?"
what is the engine size?
10w30
1993-1995 Dodge Caravan, Plymouth Voyager, Chrysler Town and Country with the same engine.
Behind the engine near the firewall
no
Its situated in the sump of the engine It is on the nose of the crankshaft.
THere is no emergency cut-off switch on a 1995 Dodge Caravan.
Yes
http://www.obd-codes.com/
Should be at the lower rear end of the engine
Any engine from a 1991-1995 Dodge Caravan, Plymouth Voyager or Chrysler Town & Country should work fine