You need to remove the old belt from the Power Steering pump. Then loosen, not remove the bolts on the alternator. Slide the belt over around and through the fan and onto the belt grove for the alternator. Then with a large bar push the alternator away so it tightens the belt. Later if not tight the belt will squeal. While putting pressure on the alternator tighten the bolts. Reinstall the power steering belt in the same way but you can tighten the belt on this one using hand pressure rather than the bar.
You will need to loosen the tensioner pulley. Put the alternator belt on. Push the tensioner pulley to the left until the alternator belt is tight. Tighten down the tensioner pulley.
Loosen the alternator tensioner bolt. The alternator belt will become loose. Remove the alternator belt. Put the new alternator belt on and reverse the process.
Yes.
Loosen the tensioner bolt on your alternator. Slide the alternator to the left. Remove the alternator belt. Put the new alternator belt on and tighten the tensioner bolt.
You will need to loosen the alternator belt with the tensioner pulley. When the tensioner pulley is loose the alternator belt will become loose. Put the new alternator belt on and tighten the tensioner pulley.
Is the timing belt on a j30 infinity run the alternator
What bolts to loosen to put alernator belt on and how to put it on when a/c belt is on.
you will have to look at the electrical connections at the back of the alternator to see if it will plug into your loom.Also you might need to look at the amps put out by both units to see if they are the same autos usually put out more there should be a label with this info hope this helps. Matt the alternator wont fit a Toyota runner it has to put more power then a corolla trust i know about Toyota
You can remove your 1993 Mitsubishi alternator belt by loosening the tensioner pulley. Slide the tensioner pulley to the right. The alternator belt will become loose and can be removed. Reverse the process to put the new alternator belt on.
put a wrench on the pulley side of the tensioner (15mm?) and turn. The pulley arm will move & loosen up the belt.
Disconnect the 1982 Regal alternator. Loosen the alternator bolts and slide to release belt tension. Put new belt on ( you may have to remove other belts to gain access) and pull the alternator sideways to put medium tension on the belt while tightening the bolts. Reconnect the battery.
Relax belt by holding automatic belt tensioner with large socket and/or breaker bar