Want this question answered?
A representative copy of a parts manual is linked below.
I need to know the number for the drive belt. The one that drives the tractor.
I think you can replace the drive belt by carefully taking off the old one and replacing it with a new one. If you need exact directions on how to take it off and put a new one on then I suggest that you call the company.
how to change drive belt z225
Begin by loosening the tensioner pulley. Take the old air conditioning drive belt on. Put the new air conditioning drive belt on and tighten the tensioner pulley.
Conventional drive, your drivetrain will be the engine, transmission, transfer case (if 4x4), driveshaft(s), differential, and axles. Hydrostatic drive, it's going to use a hydrostatic transmission and hydraulic motors to drive the wheels.
To change the drive belt.: 1. There should be a routing diagram in the engine compartment, if there is not one make note of the proper routing so you can put the new belt on correctly. 2. Release the tensioner and remove the old belt. 3. Put the replacement belt in place, then release the tensioner and put the belt over the idler pulley and loosen the tensioner.
Hydrastatic drive means the driveline is driven by hydraulics.
Absolutely NOT! WD-40 is a lubricant. The last thing you want to put on a drive belt is a lubricant. If the belt is making a noise, it is either loose or worn out.
The drive belt on a New Holland 479 haybine is replaced by first removing the outer cover and loosening the retaining bolts. The belt can then be slipped off and a new belt put in its place.
you can put a wrench or a socket on the tension pulley, releasing the pressure on the belt.
See the answer for "How do you replace the drive belt in a 2000 Ford Focus?". The procedure is the same.