First you have to dissconnect the positive battery cable. Then you have to remove the 2 5/8 bolts that hold the starter in. Then you can move the starter towards the front of the truck and swing it down nose first. Then you have to remove the thick power cable 1/2 in nut. Then the small solenoid cable. Then completely remove the starter and place it in the box the new on came it. Take the new starter and connect the solenoid wire and power wire. Place the nose back in to the hole where the fly wheel is and slightly turn the first 5/8 in bolt back in to place. Then the second 5/8 in bolt. Then tighten both down. Connet the positive battery cable and Your done.
yes
A 1995 LT1 engine can be put into a 1995 Chevy Silverado with minimal changes. This will increase the overall power and performance of the vehicle.
10000.00
Yes, They can be switched.
YES IT will fit right in. No problems.
chevy silverado ha automatic transmission . shift lever on column when put in or out of gear flops up and down . is it hard to put a spring in the column to repair
yes
2012
Did you put a starter on it ? If so, Then you have put the starter wires in the wrong place are you have the big battery wire touching the small wire that goes to the starter. Recheck the wiring on the starter.
I got a 2003 Chevy silverado 4x4 z71 stock suspension , and i install on it 285/75r16 tires, that's the biggest tire that you can use, i put that tire size to in a 2002 Chevy silverado work truck 4x2, with no problems. You can trust, good luck.
will a 2004 tailgate fit a 2006 Chevy
check w/tire shop