How do you reload a weed eater? |
Always unplug it if its electric or pull the contact wire off the spark plug if it's gas. Make sure you don't get whipped by accidently turning the power on...it will hurt you.Next, remove the screw that holds the spool onto the unit. The spool is the piece that you will refill with new line. If you have tough weeds,buy a thicker line...it lasts longer. Spool according to the arrows on the plastic casing. Reinsert onto weed whacker. Tighten screw. Reinstall the wire onto the spark plug or plug unit back into the cord. Tamp down on the ground to feed wire (most weed whackers are made like this to advance the string). Happy weed whacking. Always use the guard unless you do this professionally. Use caution if removing the guard and using it.You can use it as an edger though with the guard removed.ALWAYS wear safety glasses when using power equipment.
It is not too difficult -- you have to buy a new spool of the plastic line, and then carefully remove the old one. Then you pull out a bit of the new spool so it sticks out past the opening (about two inches will do) and snap the new spool in.
|
|
|
First answer by ID408537697. Last edit by Auntgnu. Contributor trust: 6 [recommend contributor]. Question popularity: 121 [recommend question]
|
Research your answer: |
Can you answer other questions about home, farm and garden?
|
|


