0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change ignition switch on a 93 Honda Accord?
how to change manual ignition switch on a 93 Honda accord
How do you remove and install the ignition switch on a 91 Ford Explorer?
I am working on changing my 93 Explorer ignition switch now. As soon as I figure it out I will let you know. :-) Still working on it.
How do you change the ignition switch on a 93 Nissan quest?
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.
How do you change iginition switch on 93 dodge caravan?
how do caravanu change ignition switch in 93 dodge
How do you remove the ignition switch from a 93 ford explorer?
The steering wheel has to be removed since it has Air bags this MUST be done by a professional
Where is the kill switch on 93 Maxima?
It is controlled by the ignition key. It has no inertia switch if that is what you are asking about.
How do you replace an ignition switch 93 Buick roadmaster?
fuel pump keeps running after the key is out what do I need to check I have to remove the fuses to stop the pump.
How do you remove 93 civic ignition module?
Hit it with a hammer.
How do you replace the ignition switch on a 93 2500 Chevy?
You switch the carborator with the ac and then rewire the inside to the dashboard
How do you replace the ignition lock cylinder on 93 Chevy 3500?
Pull the steering wheel with a puller tool, remove the lockplate with a lockplate tool, remove the turn signal assembly, remove the hazzard switch, remove the brass connector, remove the lock cylinder.
On a 93 Chevy cavalier- do you have to pull steering wheel to replace ignition switch?
yes
How do you remove and replace the ignition switch in a 93 LeBaron?
to replace the switch u will need the key to the old ignition switch. its as simple as getting a t15 bits to take off the steering colum and unscrewing the switch i think the bit size is t25 and you need a special bit with a hole in the center of it. you take off the steering wheel column covers.
