It has wrench flats. I think you can rotate it to loosen it.
Remove the wiring harness from your speed sensor. Remove the speed sensor retaining bolts. Reverse the process to install your new speed sensor.
Remove the wheel, remove the brake caliper, remove the brake rotor, disconnect wheel speed sensor from harness. remove the bearing hub, remove the wheel speed sensor from the bearing hub. Reverse order for install.
if your looking for the front abs sensors thay are located in the hubs, and would have to remove front tire, brakes,caliper, and rotor to remove.
Raise the vehicle and locate the speed sensor. Remove the electrical plug. Turn the speed sensor counterclockwise and remove it. Install the new speed sensor.
If you jack up the right front (passenger side) side of the vehicle and remove the right front wheel, the speed sensor can be seen and reached on the top of the transmission output housing for the right wheel.
The speed sensor is on the front passenger side of the car. Loosen the nuts on the wheel, then jack it up. remove the wheel. As you look where the wheel was, to your left is the speed sensor. It is at an angle, angled towards the back of the car. first unhook the wires attached. you can do this by hand. next, remove the bolt that is holding the speed sensor on. I believe it is a 10mm, and you will need a deep socket. once you remove the bolt, the sensor slides right out. Also, make sure you replace the "O" ring on the sensor. this is an easy job.
The speed sensor is mounted in the top of the rear differential on a 1999 F150. Remove the wires, then unbolt the sensor to remove it.
Need to know if you are asking about the vehicle speed sensor, a front wheel speed sensor or rear wheel speed sensor.
The 1990 Toyota speed sensor is located on the back of the transmission. There also is a speed sensor on the front passenger wheel.
Follow the wires to direct front center of throttle body,have to remove top,lg black cover
drivers side front, remove the wheel, and you'll see a sensor with a retaining bolt in the transmission housing.
it is on the transmission..best way to get to it is to remove pass side front wheel, remove motor mount. on top of trans is a round piece with 3 bolts and a plug. the speed sensor is there