Locksmiths have a tool that is basically a hooked piece of thin wire.
I had a broken key in the lock that i had to remove so i used a very thin piece of wire and made a small 90 degree bend in it. The idea is to slide the wire (hooked end) along the key and get to the end of the key and get the bent end of the wire hooking the tip of the key. Then simply pull the broken end of the key out. In effect you are using a small,long fishhook to get the key out.
Use a pair of pliars to bend the wire. Remember that the wire has to be thin and fairly strong. Coat hanger and bailing wire is much too thick.
While breaking the lock, if the lock was damaged then you may have to replace the lock. The key may be jammed in too tightly.
See You-Tube Video : http://youtu.be/lBNUuO4ldfI How to Remove a broken key from an Ignition. Using the Broken Key Extractor Kit from: www.WedgeCo.com
Take it out haha
Flush the lock with a lubricant. Use the handle of the broken key as a guide. Find a thin wire and stiff it along the sides of the broken key part. Hold the wire in place and remove the part.
Accidents like breaking a car key in the ignition do happen. A person can use tweezers to remove the key piece or call a professional.
If the key is broken off in the ignition of the 96 Crown Victoria it will have to be picked out. If the key is out and broken, a locksmith can use the broken pieces to make a new key or rekey the ignition.
no need to remove the broken key, you will find that you short bit when inserted into barrel will turn the barrel, at least until you get a newy
1996 rodeo- how to remove key from lock ignition?
To replace a broken key in a 91 Subaru ignition, you will need to contact a locksmith. The locksmith can cut a key to match your ignition.
Most likely the ignition cylinder where you put your key before to start your car is broken. You have to remove it and test wires in different positions of the key.
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
Check with a locksmith or see if you can find a tool called "broken key remover" it looks like a little saw blade and the teeth hook on to the key and you pull it out.
how to remove key stuck in ignition switch in Chevy colbalt