![]() |
How do you remove a door panel on a Mercury Villager?In: Mercury Villager |
[Edit] |
Answer
I have no experiance with a villager, but assuming that mercurys are somewhat similar it may help you to know how I took the door panel off of my Sable. There were 4 crutial screws to remove. Two were in the side of the panel closest to where the seat belt hangs. One was on the side closest to the hinge, about midway up the panel. The final screw was in the bottom of the pocket just bellow the handle that you use to pull the door closed (incidentaly this is the hardest on to get back in when you put it back together). Once you have removed all the screws you have to pry a section far enough from the metal of the door that you can fit your fingers behind it.
Here comes the ugly part, the panel is atached to the door with nonreversable plastic annular snaps. You have to pull hard enough to yank them out of the sockets they fit into. This means that they are now effectivly broken. They are designed to be slided out and replaced every time the panel is removed. While I'm sure you can get new ones at just about any auto-parts store, you can reuse the same one if you are carefull removing the panel. The trick is to figure out were they are as you move along the edge, put you hand as close as possible to them, and pull with a quick strong jerk so they pop out quickly and turn ruin the ribbing.
Some final considerations while removing the panel. You need to pull the handle (as if you were opening the door) so it is sticking out from the interior of the door more than laying along it. Carefull of the lock sticking through the top of the panel, you dont want to forget and bend the rod when you pull the panel away. Last, remeber that all the wireing is still atached behind the door (this is probably what you were after anyway) so you can't just pull the panel off and set it down some place.
Hope this is helpfull to you, or anyone else with a mercury for that matter. If anyone happens to know how to remove the trunk release button or the head lamp switch by any chance, please post that for me at the other question.
First answer by ID417844162. Last edit by ID417844162. Question popularity: 70 [recommend question]
|
Research your answer: |
- Is there two hoses that run from the radiator on a villager?
- Where is the thermostat located on a 2000 mercury villager?
- When you start your car it sputters and when it finally turn and you push on the gas it falls dead Could it be the pump?
- How do you change the thermostat on a 1999 mercury villager?





