0
fixtures that use double-ended lamps have two sockets usually porcelein one or both of the sockets are "spring-loaded" push into one of the sockets along the axis of the lamp and see if you feel spring tension. If not, push the other way. You may have to push hard against the spring until there is enough of a gap at the other end for the lamp end to tip out. For this reason you should wear leather gloves in case the lamp breaks in your fingers. Remember not to touch the new lamp with your bare fingers because the oil from your skin will damaged the lamp glass when it heats up
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you change halogen bulb in ls-984 torch reading combo lamp?
It is a double ended halogen bulb and I do not know how to get to it to release it from the lamp.
What type of gas is in a tungsten-halogen light bulb?
Halogen gas is in a Tungsten-Halogen Light Bulb.
Can you upgrade a 60watt halogen bulb to a 75watt halogen bulb for a shift3 entetainment projector?
yes you can
How do you remove a headlight cover on a 1995 Honda Accord?
The headlight is an assembly. To replace the headlight, you remove the bulb from the back side. It is a halogen bulb, so do not touch with bare hards before installing.
Can you use a 50 watt halogen bulb for a 100 watt halogen bulb?
Yes. It just won't be as bright.
How do you replace a halogen 150 watt tube bulb for a ceiling fan light. I can't remove the old bulb. It's is a tube asbout 4 inches long.?
It's got spring loaded clips. Press to either side and down to remove the bulb.
How do you replace a halogen 150 watt tube bulb for a ceiling fan light. I can't remove the old bulb. It's is a tube asbout 4 inches long?
It's got spring loaded clips. Press to either side and down to remove the bulb.
Can you use a 120 volt halogen bulb in place of a 110 volt halogen bulb?
Yes, the two voltages are in the same range category.
How do you change the headlight on a 1997 Jeep?
Changing a headlight There is a twist lock connection behind the light. Twist it counterclockwise to remove the fitting and halogen bulb. Remove the bulb by raising the locking clip with a small screwdriver and pulling the old bulb out. It has a double o-ring seal so it may be a little difficult to pull out. Replace with new halogen bulb. Do not touch new bulb glass as oils from your skin will cause a hot spot on the bulb and cause premature failure. Insert the twist lock, being careful to align the splines. It will only fit in one position. Once properly aligned and fully inserted twist 90 degrees clockwise to lock.
What gas is a halogen filled with?
Halogen is a gas, so your question doesn't make much sense. If you're asking about a halogen (light) bulb, then the answer is: mainly halogen.
What is a 50 watt type G-10 bulb?
It's a halogen bulb
What is the bulb type on a 2001 lanos?
Halogen H4 55 Watts bulb.
