A 1993 MB SL has 2 tops.
1: The canvas top stays in the boot.
2: The hard top can be removed from the car. There is a big button on the center console, to the rear of the shifter. Accessing this button will unlock the hard top, allowing you to hoist the top off of the car. You will need either an optional hoisting device, with a block and tackle to lift the top off the car, or two, reasonably strong men to lift the top straight up, then walk it to the rear of the car. Its not that heavy of a top, its bulky. Make sure the antenna mast is all the way down, otherwise you'll snag or break the mast. You might also want to put a towel or mat down on the trunk lid to prevent any damage which can occur when you move this bulky top
After you remove the hard top, use the same big button on the center console to activate the top, either up or down. This is a fully automated set up, and should take less than 20 seconds from start to finish to take up or down.
You might want to take some WD40 to the top's hinges just to make things run smoother. The mechanics and soft top are very expensive items which need TLC and maintenance if you want them to last and work properly. Avoid using harsh detergents on the canvas top. Those chemicals in harsh soap will make the canvas brittle and subject to tears.
DM
I have a 1993 300sl and the battery is in the trunk on the passenger side. There is a knob that has to be twisted out and the wll of the trunk should pop out revealing a car battery. Its not that hard. Hope this helps.
Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Remove the intake manifold retaining bolts from your 1993 Mercedes-Benz manifold. Remove the old manifold gasket. Clean the surface and put the new gasket on.
Disconnect the battery, and remove the electrical connection and remove the bolts, and reverse to install.
Remove the belt from your 1993 Chevy G 20 alternator. Remove the alternator wiring harness. Remove the retaining bolts from the alternator. Reverse the process to install the new alternator.
By using a tool box open the location and remove it to replace it with a new one
Remove the wiring harness from the back of your 1993 VW Jetta alternator. Remove the three alternator retaining bolts. Remove the alternator belt. Reverse the process to install your new alternator.
1993 mercedes station wagon 3.2 liter
install distributor rodeo 1993
Remove the positive battery cable from your 1993 Chevy Cheyenne battery. Remove the two cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
The belt tensioner pulley is held in place by a retaining bolt. The retaining bolt is in the center of the pulley. Remove the retaining bolt and the pulley will come off. Reverse the process to install the new pulley.
information on the 1993 Mercedes 300 e class fuse