Answers.com > Wiki Answers > Categories > Cars & Vehicles > How do you remove moisture from the inside of an automobile headlight lens?

How do you remove moisture from the inside of an automobile headlight lens?

In: Cars & Vehicles [Edit categories]

Answer:

Throw rice on it about 2 gallons 5 times

First answer by ID1660218521. Last edit by ID1660218521. Question popularity: 2 [recommend question].

[report abuse]

Can you answer these Cars & Vehicles questions?

	What truck is at the end of the roadside ditch commercial?	Answer it!
	Why is there a lien on your car?	Answer it!
	How much dose it cost for you and your car to got Tasmania by ferry?	Answer it!
	How many meters should You take before You draw the parallel line of your car's parking?	Answer it!
	How much does it cost to rebuild a rotary in New Zealand?	Answer it!

Need to remove headlight lens cover have moisture inside on 1993 Ford ranger?
I detail headlights at used car dealerships and what I do is drill a TINY hole on the lower edge of the headlight to let the water out. The heat from the light bulb will eventually dry it out. To...
How do you remove condensation from inside headlights?
You can remove the entire headlight fixture by removing 2 clamps on the back side. Pull entire fixture forward, turn over and drill 2 or 3 small holes on the bottom side of the fixture toward the...
How do I clean an automobile plastic headlight lens?
The answer to how to clean your headlight lens depends on how dirty your lens is. If it just has bug juice and road grime any good car soap will clean it, just be carefull not to scratch the plastic....
How do you clean a headlight lens that is dirty on the inside?
Dirty Headlights. Here is advice: Are you sure the light is dirty on the inside? I detail headlights at used car dealerships and most of the time the outside is dirty it only looks like the dirt...
How do you clean the inside of the headlight lens on a 1997 Toyota Avalon?
As far as moisture build up goes you can remove the entire assembly and aim a hair dryer inside the holes where the lamps go, then put it all back together. However if you're aiming to get rid of...