Answers.com > Wiki Answers > Categories > Cars & Vehicles > Auto Parts and Repairs > Car Smells > How do you remove the front seats from a 1999 Chevy Tracker?

How do you remove the front seats from a 1999 Chevy Tracker?

In: Car Smells, Brake Pads and Rotors, Chevy Tracker [Edit categories]

Answer:

Answer

Unbolt them from the floor.

First remove the plastic covers (they pop off) then remove the four bolts holding the seat down. There's one on each corner. Disconnect the seat belt sensor wire before pulling the seat out of the car.

Contributor:

Clay

First answer by Jim-B. Last edit by Jim-B. Contributor trust: 52 [recommend contributor ]. Question popularity: 55 [recommend question].

[report abuse]

Can you answer these Car Smells questions?

	Why does my car smell like its burning?	Answer it!
	How does silk smell after burning?	Answer it!
	What does Cherise White mean?	Answer it!
	What does it mean if you smell of burnt skillet?	Answer it!
	How does a car exchange gas?	Answer it!

Relevant answers:

How do you remove the front rotors on a 1999 Chevy Tracker?
Usaully they'll just pop off. If they don't, take a look at the rotor. You'll see two small threaded holes. Get two high grade metric bolts to fit those holes. Screw them in and use them as you would...
How to remove Chevy tracker seat belts?
You have to first remove the plastic cover that makes up part of the inside panel. It's the panel that receives the seat belt. This is probably the only tricky part. Once you get that off, simply...
How do you remove the radio on a 1999 Chevy tracker?
First pull out the ash tray, this is where you find the first set of screws to remove the face plate. I can't remember more because it's been a while since i did mine, but this should be enough to...
How do you remove the front rotors on a 1999 Chevy dually 4wd?
Once you have the brake calipers off, they should just pull off the wheel studs. The only thing that may be holding them on yet, would be the factory assembly rings, put on over the wheel studs to...
How do you remove brake rotors on a 1999 Chevy Tracker?
It usually pops off but if it's frozen, look for two extra threaded holes on the rotor. Get two high grade bolts that fit the holes (8mm fine?) and use them like a gear puller. You can get the bolts...