How do you remove the headlight housing froma 1990 acura integra GS and you mean the ENTIRE headlight not just the bulb?

Answer

In order to remove the headlight assembly, you must remove the bumper (which is easier than it sounds and will only take about ten minutes or less). This will also save you time and aggravasion. The reason the bumper must be removed is that there are two brackets underneath the headlight assembly that are very hard to get to without this step.

To remove the bumper: 1) remove the two screws from each of the front parking lights, 2) remove the connectors to the parking light assemblies, 3) remove two screws in each wheel well (forward area), 4) remove two 10mm bolts underneath the middle, front of the bumper, 5) remove three large head screws from the top middle of the bumper (in front of the hood latch), 6) hold the bumper and remove the two 11mm bolts from behind the parking lights - the bumper will drop after the bolts are out.

There are five 10mm bolts holding the assembly onto the car. To remove the headlight assembly. remove the top three 10mm bolts from the top black brackets. Remove the bolt from the outside bottom part of the headlight assembly and the bolt under the assembly. The two bolts on bottom are held in with brackets that can be loosened/adjusted to remove or install this assembly.

To disconnect the side marker light assembly from the headlight assembly, loosen a screw (looks like an adjustment screw) and remove the lens. Two screws hold the two assemblies together.

First answer by ID1112196080. Last edit by ID1112196080. Question popularity: 5 [recommend question]