answersLogoWhite

0


Best Answer

You need to remove the venturi from the jet pump housing by removing the steering cable and then the reverse cable (if applicable) Then remove the four nuts holding the pump housing to the seadoo. You will need to pull on the housing to remove the drive shaft from the impeller pinion, just pull staight back. Once the Pump housing is removed, there is a tool available from Seadoo, with 18 splines in it. Insert tool, and use a ratchet or impact wrench and unscrew the impeller from the craft. Hope this helps.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

14y ago

impact gun

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the impeller on a sea doo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How would i un seize a 97 xp sea doo 2 stroke motor?

remove the jet pump and insert the impeller tool into the pto flywheel. Remove spark plugs and put some lubricant down the spark plug hole and try to turn the engine over with a breaker bar on the impeller tool.


Yamaha wr correct way to remove water pump impeller?

Remove the side case and the water pump. Remove the right side case, and remove the impeller and shaft. Holding the back side of the impeller shaft with a wrench on the flat spots, you can now twist the impeller off.


When was Sea-Doo GTX created?

Sea-Doo GTX was created in 1993.


How do you change the impeller on a 9.8 mercury outboard?

The impeller on a 9.8 Mercury outboard boat motor can be easily changed. Remove the retaining bolt. The impeller will come off. Reverse the process to install the new impeller.


How do you change the impeller on the water pump on your 35 horsepower evinrude outboard boat motor?

First, remove the lower unit (there is a housing for the water pump). The drive shaft goes through the housing and turns impeller. Remove the housing, the impeller is on the shaft. Install the new impeller. When replacing the housing, turn the drive shaft clockwise to make it slide down over the impeller.


Which is better Sea Doo or WaveRunner?

Don't ever buy a Yamaha always go with sea doo. there the BEST!!!!!!!!!!!


Where is the Volvo penta impeller located?

The impeller in a Volvo Penta is located inside the water pump. You will need to first remove the water pump to access it.


What automobile had Water brakes?

A Sea-Doo.


How old do you have to be to drive a sea-doo?

16


Why does your 1996 sea doo xp take off slow it has problems getting out of water Once it finally planes out it will only go 45?

More than likely a damaged impeller if your rpms are high. If not, do a compression test on the engine, and check your plugs to see if the engine is running properly.


What is the least expensive NEW Sea-Doo?

The GTS130


What are the release dates for Scooby-Doo and Scrappy-Doo - 1979 Twenty Thousand Screams Under the Sea 1-9?

Scooby-Doo and Scrappy-Doo - 1979 Twenty Thousand Screams Under the Sea 1-9 was released on: USA: 17 November 1979 USA: 1980