Answers.com > Wiki Answers > Categories > Cars & Vehicles > Auto Parts and Repairs > Brakes and Tires > Brake Pads and Rotors > How do you remove the primary and secondary springs from the brake shoes of a 1994 Nissan Sentra?

How do you remove the primary and secondary springs from the brake shoes of a 1994 Nissan Sentra?

In: Brake Pads and Rotors [Edit categories]

Answer:

Answer

The parts store has a tool that does a good job and it is about $15

First answer by ID0000000000. Last edit by ID0000000000. Question popularity: 45 [recommend question].

[report abuse]

	What causes rotors to get pitted?	Answer it!
	Is there difference between brake disc and brake rotors?	Answer it!
	Why are brake drums and rotors on a car thick?	Answer it!
	Why disc brake pull to right side?	Answer it!
	Why is your right front brake grinding weeks after being replaced?	Answer it!

How do you remove the radio on a 1994 Nissan Sentra?
This is easy if you haven't already figured it out. Remove the 4 screws holding the black dash cover 2 top 2 bottom. Remove the ashtray. Pop the black plastic cover around the shifter. It pops up...
How do you remove the brake drum from 1996 Nissan sentra?
They just pull off but parking brake must be released & you may have to tap it. Shoes tend to fit pretty tightly in there.
How do you remove the rear brake drums on a 1994 Nissan Primera?
Never worked on this particular vehicle. Memory serves that your have to remove the grease cap on the center of the hub and remove the axle nut itself. BEFORE DOING THIS be sure you have the...
How do you remove the rear speakers of a 1994 Nissan sentra xe?
You remove the lower seat cushion by pulling the white tabs toward the front of the car and then you lift up and take out the cushion. Then you remove the seat back by removing the two screws on each...
How do you remove the rear brake drum on a 1993 Nissan sentra?
remove the wheel wih 4 bolts.and pull outh the drum.if the drum is tightly fitted open the pulg behind the hub.you can find the rubber blug down the hydrolic line.remove the plug and use flat screw...