answersLogoWhite

0


Best Answer

For 2005 Corolla (may fit Corolla 2001 - 2005)

Tools reruired:

1/ 4 mm slot screwdriver

2/ #1 Philip hear screwdriver

3/ 10 mm socket and 1/4" drive

4/ 10 mm deep socket

5/ 6" 1/4" drive extension.

Procedures:

1/ Remove spare wheel cover assembly

2/ Remove rear floor finish plate by:

a/ remove the 3 clips
b/ use a screwdriver to pry out the rear floor finish plate carefully.

3/ Remove the luggage compartment trim cover inner LH by remove 4 clips.

4/ use same manner to remove the luggage compartment trim cover RH.

5/ Disconnect the rear bumper side seal LH.

6/ Disconnect the rear bumper side seal RH.

7/ Remove the rear bumper cover by removing
a/ 4 nuts with 10 mm deep socket
b/ 2 screws inside the bumper cover
c/ 6 clips at the bottom of the bumper cover
d/ Disengaged the hooks and remove.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the rear bumper from a Toyota Corolla?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove rear seat of Toyota Corolla?

The type of the rear seat of the Toyota Corolla will determine how you will remove it. For instance, for a folding seat, all that you will need to do is to lower the seat to gain access.


How much will it cost to replace the rear bumper on a Toyota corolla 2013 S?

probably $1000-1500


How do you remove the rear cup holder on a 1998 Corolla LE?

To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.


Where are the indicators lights of Toyota Corolla located?

Front and rear of the vehicle just above the bumper. Side repeaters on the front wings.


How do you remove 2006 Toyota corolla rear bumper?

InstructionsLift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands.Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver.Remove the bolts that hold the bumper to the bumper bracket and support.Pull the bumper off the bumper support.Mount the new bumper. Align the mounting holes on the back of the bumper's mounting bracket with the bumper support, and thread and tighten the bumper. Replace the plastic rivets that hold the wheel liner to the rear bumper.Remove the jack stands, and lower the car.


What is the rear hip room of the 2014 Toyota Corolla?

The 2014 Toyota Corolla has 43.9 in. of rear hip room.


What is the rear shoulder room of the 2010 Toyota Corolla?

The 2010 Toyota Corolla has 54.6 in. of rear shoulder room.


What is the rear shoulder room of the 2003 Toyota Corolla?

The 2003 Toyota Corolla has 53.5 in. of rear shoulder room.


What is the rear shoulder room of the 2012 Toyota Corolla?

The 2012 Toyota Corolla has 54.7 in. of rear shoulder room.


What is the rear leg room of the 2012 Toyota Corolla?

The 2012 Toyota Corolla has 36.3 in. of rear leg room.


What is the rear head room of the 2009 Toyota Corolla?

The 2009 Toyota Corolla has 37.2 in. of rear head room.


What is the rear shoulder room of the 2001 Toyota Corolla?

The 2001 Toyota Corolla has 52.2 in. of rear shoulder room.