You need a special tool to get the window crank off then take out all of the screws you can find {In each corner etc}. Then you need a "J" shaped tool with a "V" in the end to pull out the nylon retainers that are all around the outside of the trim pannel. They hang in there pretty good so you need a good puller to get them out. Both tools are available at good parts stores and you may want to rent them but they aren't very expensive.
To remove the door panel on a 2000 Olds Intrigue, remove the lenses off any lights in the door. Then remove the screws holding in the light assembly. Using a screwdriver, gently pop off the clips in the corners and on the sides.
You remove the four large Phillips screws (2 in the carpeted area and 2 in the door grab) and then pop off the plastic trim tabs starting from the bottom and moving to the top. The top area clips over the window edge. If you are changing the window motor off the plastic vapor barrier to expose the motor rivets. If you are changing out the door handle you have to squeeze you hand in to access the nuts holding the handle.
i cant open my fuel door
installing the mirror is simple enough. 3 nuts hold it on. the problem is that the electrical lead goes too far down into the door panel to get at it without removal of the door panel. that's the real problem and I can't find info on that without buying the chassis manual at $100.
pop the switch panel off and then the door mount support with a socket
5 1/4"
To repair the power window on the 1998 Old Intrigue, you will first need to remove the interior door panel to access the window motor, switch, and actuator. You can then determine which part is broken or damaged and replace that part.
Driver's side along the edge under the back door.
remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.
Opening the driver door of a 2000 Cadillac Seville is easy. All you have do is pop off the door panel.
The screws are around the door handle and the door latch pop out the plastic behind the latch their may be a screw underneath the door panel and lift the window switch cover out from the bottom next to the handle striaght up off the metal clip slide it through the door then just pop it off the retainers
Go to this website. It will show how to remove the door panel.
You would need to remove all of the trim pieces from it, and then pry it off of the door with a door panel removal tool. An instructional video has also been included below, to help walk you through the correct steps on removing the door panel.
i dont have a answer i want a answer