Answers.com > Wiki Answers > Categories > Cars & Vehicles > European Cars > BMW > BMW 3-Series > How do you remove the rear seat in a 1993 BMW 525i?

How do you remove the rear seat in a 1993 BMW 525i?

In: BMW 3-Series [Edit categories]

Answer:

pull the little plastic piece out that goes around the passenger side rear belt plug in. then just grab the cushion part of the passenger side rear seat and pull up kinda hard. the whole rear cusion should pop out.

First answer by ID1121426084. Last edit by ID1121426084. Question popularity: 1 [recommend question].

[report abuse]

Can you answer these BMW 3-Series questions?

	What does the warning yellow symbol like a house with a chimney mean on a 5 series BMW?	Answer it!
	What does the symbol delta H stand for?	Answer it!
	Can a new crank case valve improve performance?	Answer it!
	Why does your BMW diesel cut out when cold?	Answer it!
	Who is the actor doing the BMW radio ads?	Answer it!

Relevant answers:

How do you remove rear seat in BMW 318?
I have a 1993 318i 4-door. Rear seat removal is extremely easy. The seat is held in place by 2 clamps in the seat which fit over corresponding fittings on the chassis. These clamps are positioned...
How do you remove rear seat in 1992 BMW 325is?
Just pull it out. No screws or anything
How do you remove the rear seat in a 2004 BMW 5 series?
Takes some finess and strength at same time. There are two tabs, heavy spring like metal tabs, push seat bottom at both sides and then pull up at same time, so push seat bottom back and lift, it...
Where is the PCV on a 1993 BMW 525i?
bmw do not use a pcv valve system, instead they use a cyclone seperator system, and crankcase vent valve. the system is located under the intake manifold. comming problems are they rubber inside go...
Where is the antenna on a 1993 BMW 525i?
Can somebody answer the question