remove shift knob
remove shift boot
at the base of shift lever, there is a metal ring, push down, and turn it to the left.
-there is a special tool to do this, but two flat head screw drivers work
On a manual transmission the bushing is located below the top cover of the transmission. remove the shifter boot and unbolt the 3-4 bolts that hold the shifter down.only available from your local dealer.
Remove boot There should be 4 bolts that hold the shifter into the transmission Make sure transmission is in neutral when removing
Where do I add transmission fluid to a 1994 Ford explorer with a manual transmission?
support rear of engine. remove drive shaft. remove transmission. remove cluth. remove fly wheel. reinstall is exact opposite of removal
If you can remove the transmission pan then you do not have to remove the transmission.
there is a clip on the front of the shifter. pull this out and the outer part of the shifter will come off. next remove the center console. then you can get to the 4 bolts that hold the shifter in place.
Refer to your Chilton's manual.
There is a fill plug on the side of the 1994 Camaro transmission. Remove the plug to check the fluid. The fluid should be high enough to be just before running out of the plug hole.
A manual transmision doesnt use transmision fluid
The manual transmission doesn't have a dipstick , there will be a fill plug on the transmission underneath the vehicle
either the shifter linkage is not fully engaged in park or the park lock is broke inside the transmission
The manual transmission in a 1994 Cherokee uses 80 W 90 gear oil, not ATF.