There are two screws located behind the temperature knob and the vent knob located below the stereo. To get to these screws you have to pull out on these two knobs and then remove the screws with a Phillips screw driver. Once they are removed the grey trim around the stereo and ac/ heater unit should come right off. remove the trim and locate the screws on each side of the stereo. Remove these screws and slide the stereo out of its compartment, being careful not to damage the wiring harnesses and the antenna cable. Remove the wiring harness by pressing in on the quick release tabs on the sides of the plastic connector and gently wiggle the connector from side to side while pulling out away from the stereo. Then if not already disconnected, pull the antenna wire out of the slot. Your stereo should be completely disconnected and you will have to buya wiring harness adapter for the '03 Lancer to properly install an aftermarket stereo. You can usually find these adapters at any car audio store or electronics store. You are now ready to install your new stereo.
The 2003 Mitsubishi Lancer has 16 valves.
The 2003 Mitsubishi Lancer has an inline 4 engine.
The 2003 Mitsubishi Lancer is a gas-powered vehicle.
The 2003 Mitsubishi Lancer has a 5-speed manual.
The 2003 Mitsubishi Lancer-Evolution has 16 valves.
The height of the 2003 Mitsubishi Lancer is 4 ft. 6.1 in. (54.1 in.).
The 2003 Mitsubishi Lancer runs on regular unleaded.
The 2003 Mitsubishi Lancer's turning circle is 32.8 ft..
The 2003 Mitsubishi Lancer has single overhead cam (SOHC).
The 2003 Mitsubishi Lancer is 14 ft. 9.6 in. (177.6 in.) long.
The curb weight of the 2003 Mitsubishi Lancer is 2646 lbs..
How do you replace the timing belt on a 2003 Mitsubishi Lancer?