Answers.com > Wiki Answers > Categories > Cars & Vehicles > American Cars > Oldsmobile > Oldsmobile Achieva > How do you remove the transaxle support bracket on a 1994 Olds Achieva?

How do you remove the transaxle support bracket on a 1994 Olds Achieva?

In: Oldsmobile Achieva [Edit categories]

Answer:

take driver side wheel off make sure you support the vehicle and have a jack to lower sub frame down a little. remove 2 of 4 18mm bolts that hold the sub frame on that side and lower down. but first remove the 3 15mm bolt out of the side the transmission and there is a17mm bolt with a 15mm nut for the center of the mount then side out the front.

First answer by Stucinarut. Last edit by Stucinarut. Contributor trust: 10 [recommend contributor ]. Question popularity: 53 [recommend question].

[report abuse]

Can you answer these Oldsmobile Achieva questions?

	What does the Prince say will happen to anybody who starts further trouble?	Answer it!
	How do I find my cars motor mounts?	Answer it!
	Where is torque converter clutch circuit located?	Answer it!
	Is it necessary to replace complete rack pinion or can you just install new seals when the steering is leaking Assuming power steering fluid seal would not work?	Answer it!
	Where is the shift lock switch on Olds Achieva?	Answer it!

Relevant answers:

How change themastat in a 1994 olds achieva?
the thermostat is located on the passenger side rear of engine, directly under the #2 and #3 exhaust manifolds. .......drain coolant , ...on the lower radiator hose there is a stabilizer mount ..pull...
How do you remove window crank from 1993 olds achieva?
ay have a horse shoe type clip at the rear behind handle removal tool available at auto parts
How do you remove window crank from 1996 olds achieva?
If it's a manual window, there should be a horseshoe clip that holds it in place. The best way, short of a special tool, it to get between the handle and the spacer plate between the door panel and...
Will a trans from a 1991 olds cutlass 3.1l fit in your 1994 olds achieva 3.1l?
i think it would fit but the '94 is updated with electronics so the '91 would physically fit but would not operate properly.
How do you remove crankshaft bracket from 1990 olds ciera?
Take the crankshaft bolt off,big bolt holding the crankshaft to the engine,can be a little difficult pull the crankshaft out and the bolts should be right there,go in through the wheel well,youll...