# Pry the plastic cap off the nut at the base of the wiper # Unscrew the nut # Use a small gear puller (battery clamp puller might work) to pull the wiper arm straight off the shaft. Do not pry under the wiper arm to pull it off. If you do, you will break the plastic cowl underneath and still will not have the arm removed.
# Lift the arm away from the glass # Using a flat screwdriver, slide the locking clip down. The arm should stay up. # In theory, the wiper can now be pulled straight off the shaft. In practice, the wiper arm is likely corroded all to hell and stuck to the shaft. You will need penetrating oil and possibly heat to get it off. You may even have to cut a slit in the wiper arm base. Do not apply too much force while pulling the arm off. If it's stuck, try something else. Do not rock the motor shaft side to side or up and down. If using heat, be careful not to melt the door or the plastic nut on the motor shaft.
The Lumina liftgate, just as most of it's other body panels, is plastic composite. It can be broken quite easily if the wrong force is applied to it.
http://letmegooglethatforyou.com/?q=how+to+remove+wiper+arms
you can buy a removal tool for these quite cheap at any auto parts store
To remove the wiper arms from a 1996 Concord, remove the small clip holding them on. Then pull up on the arm.
You will have to remove the wiper arms, then remove the cowl, and then the wiper motor.
How do you remove the wiper arms on 2001 Lincoln LS
remove wiper arms and cowl
how do you remove the wiper arms on a 2002 CRV?
lift up the wiper arm and look under it near the base and there should be a little pull lever that should slide out away from wiper might take alittle prying it will also lock wiper up off of windshield then lift wiper off of stem and reposition the way u want lift wiper arm push lever in and release wiper arm
Take off the bolts at the bottom of the wiper arms and you may have to wiggle the arms back and forth to work the wiper arms off.
first remove wiper arms from vehicle next with ignition on, turn wipers on then off. the wiper motor will stop at the down position. replace wiper arms onto shaft ,in the correct down position where you want them. now with ignition on, try wipers again,to check if in the stop position you want them.
remove the cowl & wiper arms (mark location of arms on the windshield). disconnect the battery, Disconnect wire connector at wiper motor & remove the 4 mounting bolts then remove the linkage from motor.
There is a plastic cap at the base of the wiper arm. You will need to pry it up to reveal the nut underneath. Remove the nut and pry up. BE VERY CAREFUL NOT THE HIT THE WINDSHIELD WITH THE WRENCH.