0
How do you repair concrete where carpet tack strips have been removed?
Wiki User
∙ 14y ago
Normaly this is not repaired. Just floor over it.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
I want to put up a banister Below ground level in the stairway behind the drywall is concrete How do I anchor into the concrete for my banister?
If the drywall is directly onto the concrete, drill into the concrete and use a shield and screw or there is a concrete screw called Tapcon that screws directly into the concrete without a shield and holds much better. If the drywall is on furring strips, either mount the banister on the strips or go through the strips into the concrete.
A piece of carpet is 68.58 cm wide how many strips of carpet will take to cover the width of a room that is 5.5 wide?
8.019
When coal is removed in strips it is called?
it is called surface mining
How do you remove carpeting?
Carpet is almost always held down around the edges with nailed down tac strips. You just grab an edge somewhere and tear it up off the floor. You'll then have to remove the tac strips. Try pulling up a corner maybe and looking underneath. You'll see. note: it's possible it was glued down but you remove it the same way. The glue leaves a mess though and you gotta scrape it off. Hope not.
Why are pieces of rubber placed between slabs of concrete?
Concrete expands and contracts depending on the temperature. The strips are called expansion joints.
How do you remove velcro glue strips from carpet?
You heat the back of them with a hairdryer as you slowly pull it off.
How many strips of a carpet 67.0 cm wide can be used to cover a room that is 5.4 m wide?
1 strip = 67.0 cm room = 540.0 cm 540/67 8.06 strips or 9 strips will do it.
How does one install a carpet underlay?
To install a carpet underlay follow these five easy steps. 1) Prepare the subfloor, 2) install tackless strips around the perimeter of the room, 3) Cut the underlay in strips long enough to cover the tackless strips, 4) staple underlay to the subfloor and trim to the inside of the tackless strip, 5) make sure seams don't overlap and finished with carpet tape on all seams.
When a concrete road is put down black asphalt stripes are placed between sections of the concrete to?
Prevent or reduce cracking of the concrete due to thermal expansion. Most materials expand when heated and contract when cooled. The strips are usually a fibrous material that allows the concrete expand and contract without breaking. Without those strips, random and irregular cracks would occur.
How do you lay tack strips on top of laminate flooring?
You don't, if you want your carpet to stay stretched and flat on your floor. You see, laminate flooring is not attached to your floor in any way. It floats. The boards are locked together, but if you pull up on the side of a board, it will detach itself easily. So if you attach tack strips to that laminate and then stretch a carpet over it, the tension of the carpet will very likely pull your laminate up at the edges. To do this the right way, you'll need to remove the laminate flooring (you'll find this VERY easy to do), install tack strips to the subflooring, install carpet pad, and then carpet. It'll stay like it's supposed to.
Do command strips leave sticky residue when removed?
no, it even shows it on the commercial
Concrete Landscape ?
form_title=Concrete Landscape form_header=Is your driveway wide enough? Does your patio extend far enough? Would you like steps that incline? Concrete landscape services can resolve any of these problems for you. Where would you like concrete installed? (Check all that apply)= [] Walkway [] Driveway [] Patio [] Pool Deck [] Steps [] Footings/Curbs [] Mow Strips [] Other What type of service will you need?= () Small Repair () New Construction () Reconstruction Are you interested in lighted borders?= () Yes () No
