Either carefully pry off the rear light trim covers, or unfasten the retainers then remove the trim covers.
If necessary, you can unplug the electrical connector from the bulb assembly.
Remove the bulb socket from the light assembly by turning it counterclockwise 1/4 of a turn.
To remove the bulb, carefully pull it straight out of the socket.
Installation is the reverse of the removal procedure.
To ensure that the replacement bulb functions properly, activate the applicable switch to illuminate the bulb which was just replaced. If the replacement light bulb does not illuminate, either it is faulty or there is a problem in the bulb circuit or switch. Correct as necessary.
Open the trunk and remove the back plastic piece (if covered) from the backside of the taillight...locate the burned out bulb by turning on your headlights...when you find the bulb that is burned...
i assume it is the brake light that is inside the car above the parcel shelf. You will need to get a screwdriver and on the underside of the brake light there will to two holes - inside are the...
You have to go through the trunk. There should be a plastic panel that pops right off. just unscrew the round cable that the bulb is attached to and you can pull it out, replace the bulb, and pop it...
Related topics:
Honda Accord
(Japan and Europe seventh generation)